• 100 Watts RMS per output (4 Ohm)
• 85 Watts RMS per output (8 Ohm)
• 200 Watts RMS into 70 Volt (8 Ohm)
• 1/4" and RCA inputs
• Fault Protected Output Stage

The RA2100B is intended for professional audio and distributed musical applications. The unit also features MOSFET drivers in a voltage and current gain circuit and a one-second input turn-on delay. The RA2100B will drive 25 Volt speaker lines directly from each channel, or 70 Volt lines bridged.

• Small size with mounting tabs
• Balanced and Unbalanced Inputs
• Phoenix type input and output
• Low cost, helps win your bid
• Optical Limiter for maximum clean power output
• Bridge switch for 40W mono operation
• Included 24 VDC inline IEC power supply

• Load: Page/Music 4 Ohms 20% pwr cycle
• Frequency Response: 5 Hz - 40 kHz
• Input Impedance: 47 K Ohms
• Equiv. In Noise: 100 mV typical, A Weighted, 600 Ohms
• Gain: 34 dB
• S/N Ratio: 114 dB @ 35 Watts
• 35W/ch 4ohm 30W/ch 8ohm
• Size: 19" x 1.75" x 5" (48 x 4.5 x 12.7 cm)
• Weight: 5.5 lbs (2.5 kg)
• Power: 120 VAC 50-60 Hz
• 35 Watts per channel of clean amplification
• 1/4" and RCA inputs
• Convenient spring-loaded output terminals
• Front panel heat sinking for proper venting
• Protected output stage